Difference between revisions of "Britannia"

From Thermionic Studios
Jump to: navigation, search
m (Bypass:True)
m
Line 72: Line 72:
 
[[Category:Overdrive Pedals]]
 
[[Category:Overdrive Pedals]]
 
[[Category:PCB-Only Pedals]]
 
[[Category:PCB-Only Pedals]]
[[Category:1776Effects Pedals]]
+
[[Category:1776 Pedals]]
 
[[Category:Thermionic Pedals]]
 
[[Category:Thermionic Pedals]]

Revision as of 06:16, 24 October 2018

The Britannia is a pedal architecture developed by RunoffGroove.com for the purpose of building a sound-alike pedal of the Vox AC-30 with Top Boost amplifier. 1776 Effects developed the printed circuit board(PCB) to match the schematic developed by ROG.

Thermionic Studios has purchased this PCB and sourced the parts necessary to build this pedal. We are in the process of building the pedal and will have more to report upon completion.

Controls

  • Knob 1 - Bass: Sets the amount of bass frequencies in the signal with most bass available when control is fully clockwise.
  • Knob 2 - Treble: Works like an AC/30 amp by boosting treble and upper midrange while cutting bass as control is turned clockwise.
  • Knob 3 - Brilliance: Sets the amount of treble after the preamp section, increasing treble as control is turned clockwise
  • Knob 4 - Gain: Sets the amount of overdrive in the preamp section, increasing as control is turned clockwise.
  • Knob 5 - Volume: Sets the volume level of the pedal with volume increasing as control is turned clockwise.
  • Footswitch 1 - "On/Off": This switch toggles the effect on and off.

Bypass: True

The Brittania is a true bypass pedal.

General Information

http://1776effects.com/wp-content/uploads/2015/03/Britannia-BOM.pdf

The Britannia can be powered by a 9-volt battery, or a tip-negative Boss-style 9-volt power adapter. The transistors must be biased correctly for this pedal, sound-wise, to sound as accurate as possible to an actual Vox AC/30 amplifier.

Pedal Manual

As of this time, 1776 Effects has not issued a separate manual on how to use the pedal. The best references are either this wiki page, the entry on the Runoff Groove website, or the build manual from 1776 Effects which describes the architecture of the pedal.

Runoff Groove offers the following advice when attempting to use the Britannia with a treble booster:

If you would like to use a treble booster at the input of Britannia like Brian May did into the AC-30 Normal channel, we recommend that you start with the following configuration: set the Bass control at maximum, the Treble control at minimum, and the Brilliance control at noon; adjust the Gain control as desired, and then fine-tune the sound to your liking with the Bass, Treble and Brilliance controls. Use of a flat or full frequency booster in front of Britannia will also produce some interesting sounds.

Phase Inversion: Yes

From our examination of the schematic below, the Britannia appears to invert phase on the output as compared with the signal that goes into the pedal.

Schematic ID Electronic Part Action Phase State
Q1 2N5457 Inverts Inverted
Q2 J201 Inverts Reverted
Q3 2N5088 Does not Invert Reverted
Q4 J201 Inverts Inverted
IC1a TL072 Does not Invert Inverted
IC1b TL072 Does not Invert Inverted

This will need to be borne out by testing and observation.

Schematic

© Copyright 2013, runoffgroove.com

Artists

We are currently unaware of any artists actively using the pedal now, or who have in the past.


Additional Sources