Difference between revisions of "Multiplex Echo Machine"
From Thermionic Studios
(Created page with " [http://1776effects.com/wp-content/uploads/2015/03/Multiplex-Build-Doc-1.7.pdf Build Instructions]") |
|||
| Line 2: | Line 2: | ||
[http://1776effects.com/wp-content/uploads/2015/03/Multiplex-Build-Doc-1.7.pdf Build Instructions] | [http://1776effects.com/wp-content/uploads/2015/03/Multiplex-Build-Doc-1.7.pdf Build Instructions] | ||
| + | |||
| + | Controls: | ||
| + | * Delay 1: Sets the delay time of the first delay | ||
| + | * Delay 2: Sets the delay time of the second delay | ||
| + | * Feedback: Repeats.. .. .. .. | ||
| + | * Mix: Adjusts the dry/wet blend | ||
| + | * Tape Mode (SW1): Changes the way the signal is routed through the PT2399’s to simulate tape delays of the past. | ||
| + | ** Binson | ||
| + | ** Space Echo | ||
| + | ** Echoplex | ||
| + | * Tape Speed: Holding down the SPST momentary footswitch slowly speeds up the delay speed. Releasing it slows the speed back down to your time setting. It’s highly interactive depending on how you have Delay 2 set. | ||
Revision as of 19:07, 9 December 2017
Controls:
- Delay 1: Sets the delay time of the first delay
- Delay 2: Sets the delay time of the second delay
- Feedback: Repeats.. .. .. ..
- Mix: Adjusts the dry/wet blend
- Tape Mode (SW1): Changes the way the signal is routed through the PT2399’s to simulate tape delays of the past.
- Binson
- Space Echo
- Echoplex
- Tape Speed: Holding down the SPST momentary footswitch slowly speeds up the delay speed. Releasing it slows the speed back down to your time setting. It’s highly interactive depending on how you have Delay 2 set.
