Difference between revisions of "Multiplex Echo Machine"
From Thermionic Studios
(→Controls) |
|||
| Line 1: | Line 1: | ||
| + | {| align="right" | ||
| + | | __TOC__ | ||
| + | |} | ||
| − | + | ==Controls== | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
* Knob 1 - "Delay 1": Sets the delay time of the first delay | * Knob 1 - "Delay 1": Sets the delay time of the first delay | ||
* Knob 2 - "Delay 2": Sets the delay time of the second delay | * Knob 2 - "Delay 2": Sets the delay time of the second delay | ||
| Line 17: | Line 14: | ||
* Footswitch 1 - "On/Off": This switch turns the effect on and off in the signal chain | * Footswitch 1 - "On/Off": This switch turns the effect on and off in the signal chain | ||
* Footswitch 2 - "Tape Speed": Holding down the momentary footswitch slowly speeds up the delay speed. Releasing the switch slows the speed back down to the time setting of the knob. The tape speed is highly interactive depending on how you have "Delay 2" set. | * Footswitch 2 - "Tape Speed": Holding down the momentary footswitch slowly speeds up the delay speed. Releasing the switch slows the speed back down to the time setting of the knob. The tape speed is highly interactive depending on how you have "Delay 2" set. | ||
| + | ==General Information== | ||
| + | |||
| + | |||
| + | ==Phase Inversion== | ||
| + | |||
| + | |||
| + | ==Pedal Manual== | ||
| + | |||
| + | |||
| + | ==Schematic== | ||
| + | |||
| + | |||
| + | ---- | ||
| + | ;Additional Sources | ||
| + | [http://1776effects.com/wp-content/uploads/2015/03/Multiplex-Build-Doc-1.7.pdf Build Instructions] | ||
Revision as of 01:55, 2 February 2018
Controls
- Knob 1 - "Delay 1": Sets the delay time of the first delay
- Knob 2 - "Delay 2": Sets the delay time of the second delay
- Knob 3 - "Feedback": Increases / decreases the number of repeats
- Knob 4 - "Mix": Adjusts the dry/wet blend
- Knob 5 (3-position switch) - "Tape Mode": Changes the way the signal is routed through the PT2399’s to simulate tape delays of the past:
- Binson Echorec
- Roland RE-201 Space Echo
- Echoplex v. Ep3
- Footswitch 1 - "On/Off": This switch turns the effect on and off in the signal chain
- Footswitch 2 - "Tape Speed": Holding down the momentary footswitch slowly speeds up the delay speed. Releasing the switch slows the speed back down to the time setting of the knob. The tape speed is highly interactive depending on how you have "Delay 2" set.
General Information
Phase Inversion
Pedal Manual
Schematic
- Additional Sources
