Difference between revisions of "Multiplex Echo Machine"

From Thermionic Studios
Jump to: navigation, search
(General Information)
Line 15: Line 15:
 
* Footswitch 2 - "Tape Speed": Holding down the momentary footswitch slowly speeds up the delay speed.  Releasing the switch slows the speed back down to the time setting of the knob.  The tape speed is highly interactive depending on how you have "Delay 2" set.
 
* Footswitch 2 - "Tape Speed": Holding down the momentary footswitch slowly speeds up the delay speed.  Releasing the switch slows the speed back down to the time setting of the knob.  The tape speed is highly interactive depending on how you have "Delay 2" set.
 
==General Information==
 
==General Information==
 
+
http://1776effects.com/wp-content/uploads/2015/03/Multiplex-Build-Doc-1.7.pdf
  
 
==Phase Inversion==
 
==Phase Inversion==

Revision as of 09:28, 12 February 2018

Controls

  • Knob 1 - "Delay 1": Sets the delay time of the first delay
  • Knob 2 - "Delay 2": Sets the delay time of the second delay
  • Knob 3 - "Feedback": Increases / decreases the number of repeats
  • Knob 4 - "Mix": Adjusts the dry/wet blend
  • Knob 5 (3-position switch) - "Tape Mode": Changes the way the signal is routed through the PT2399’s to simulate tape delays of the past:
    1. Binson Echorec
    2. Roland RE-201 Space Echo
    3. Echoplex v. Ep3
  • Footswitch 1 - "On/Off": This switch turns the effect on and off in the signal chain
  • Footswitch 2 - "Tape Speed": Holding down the momentary footswitch slowly speeds up the delay speed. Releasing the switch slows the speed back down to the time setting of the knob. The tape speed is highly interactive depending on how you have "Delay 2" set.

General Information

http://1776effects.com/wp-content/uploads/2015/03/Multiplex-Build-Doc-1.7.pdf

Phase Inversion

Pedal Manual

Schematic

© copyright 2016, 1776Effects.com



Additional Sources

Build Instructions