Amp Selector FX Router

BYOC Amp Selector FX Router

Controls

• Switch 1 - "Transformer 1 Isolation Switch":
• Switch 2 - "Transformer 2 Isolation Switch":
• Footswitch 1 - "Both/One":
• Footswitch 2 - "A/B":

General Information

http://byocelectronics.com/ampselectorinstructions.pdf

Phase Inversion

Our review of the schematic draws us to conclude that the BYOC Amp Selector and Stereo FX Router does not invert phase.

Electronic Part	Action	Phase State
IC1a	Does not Invert	Original
IC1b	Does not Invert	Original
IC2a	Does not Invert	Original
IC3a	Does not Invert	Original
IC3b	Does not Invert	Original

This will have to be born out by testing and observation.

However, many on the BYOC board forums have looked at the Amp Selector/FX Router and asked if it isn't possible to use the remaining half of IC2 in order to invert the signal and make it available through Output B.

Here are a few threads on the byoc discussion boards about enabling the phase inversion:

http://www.byocelectronics.com/board/viewtopic.php?f=52&t=44330

http://www.byocelectronics.com/board/viewtopic.php?f=12&t=32756&hilit=amp+selector+phase

Pedal Manual

As of this time, BYOC has not issued a separate manual on how to use the pedal. The best reference is either this wiki page, or the instruction manual (linked above in General Information) at Buildyourownclone.com which describes the architecture of, and how to build the pedal.

Schematic

© Copyright 2011, BYOC LLC.

---

Additional Sources