Difference between revisions of "Amp Selector FX Router"
m (→Phase Inversion) |
m (→Phase Inversion) |
||
| Line 34: | Line 34: | ||
This will have to be born out by testing and observation. | This will have to be born out by testing and observation. | ||
| − | However, many on the BYOC board forums have looked at the Amp Selector/FX Router and asked if it isn't possible to use the remaining half of IC2 in order to | + | However, many on the BYOC board forums have looked at the Amp Selector/FX Router and asked if it isn't possible to use the remaining half of IC2, and some of the remaining empty pads on the PCB in order to set up a switch that will toggle the inversion of the signal and make the possibility of an inverted signal available through Output B. |
Here are a few threads on the byoc discussion boards about enabling the phase inversion: | Here are a few threads on the byoc discussion boards about enabling the phase inversion: | ||
Revision as of 20:41, 13 February 2018
BYOC Amp Selector FX Router
Controls
- Switch 1 - "Transformer 1 Isolation Switch":
- Switch 2 - "Transformer 2 Isolation Switch":
- Footswitch 1 - "Both/One":
- Footswitch 2 - "A/B":
General Information
http://byocelectronics.com/ampselectorinstructions.pdf
Phase Inversion
Our review of the schematic draws us to conclude that the BYOC Amp Selector and Stereo FX Router does not invert phase.
| Electronic Part | Action | Phase State |
|---|---|---|
| IC1a | Does not Invert | Original |
| IC1b | Does not Invert | Original |
| IC2a | Does not Invert | Original |
| IC3a | Does not Invert | Original |
| IC3b | Does not Invert | Original |
This will have to be born out by testing and observation.
However, many on the BYOC board forums have looked at the Amp Selector/FX Router and asked if it isn't possible to use the remaining half of IC2, and some of the remaining empty pads on the PCB in order to set up a switch that will toggle the inversion of the signal and make the possibility of an inverted signal available through Output B.
Here are a few threads on the byoc discussion boards about enabling the phase inversion:
http://www.byocelectronics.com/board/viewtopic.php?f=52&t=44330
http://www.byocelectronics.com/board/viewtopic.php?f=12&t=32756&hilit=amp+selector+phase
Pedal Manual
As of this time, BYOC has not issued a separate manual on how to use the pedal. The best reference is either this wiki page, or the instruction manual (linked above in General Information) at Buildyourownclone.com which describes the architecture of, and how to build the pedal.
Schematic
- Additional Sources
