Difference between revisions of "Amp Selector FX Router"
m |
m (→Phase Inversion) |
||
| Line 23: | Line 23: | ||
| IC1a || Inverts || Inverted | | IC1a || Inverts || Inverted | ||
|- | |- | ||
| − | | IC1b || | + | | IC1b || Does not Invert || Original |
|- | |- | ||
| − | | IC2a || Inverts || | + | | IC2a || Inverts || Inverted |
|- | |- | ||
| IC3a || Inverts || Inverted | | IC3a || Inverts || Inverted | ||
|- | |- | ||
| − | | | + | | IC3b || Inverts || Reverted |
|} | |} | ||
Revision as of 19:54, 13 February 2018
BYOC Amp Selector FX Router
Controls
- Switch 1 - "Transformer 1 Isolation Switch":
- Switch 2 - "Transformer 2 Isolation Switch":
- Footswitch 1 - "Both/One":
- Footswitch 2 - "A/B":
General Information
http://byocelectronics.com/ampselectorinstructions.pdf
Phase Inversion
Our review of the schematic draws us to conclude that the BYOC Amp Selector and Stereo FX Router does not invert phase.
| Electronic Part | Action | Phase State |
|---|---|---|
| IC1a | Inverts | Inverted |
| IC1b | Does not Invert | Original |
| IC2a | Inverts | Inverted |
| IC3a | Inverts | Inverted |
| IC3b | Inverts | Reverted |
This will have to be born out by testing and observation.
However, many on the BYOC board forums have looked at the Amp Selector/FX Router and asked if it isn't possible to use the remaining half of IC2 in order to invert the signal and make it available through Output B.
Here are a few threads on the byoc discussion boards about enabling that phase inversion:
http://www.byocelectronics.com/board/viewtopic.php?f=52&t=44330
http://www.byocelectronics.com/board/viewtopic.php?f=12&t=32756&hilit=amp+selector+phase
Pedal Manual
As of this time, BYOC has not issued a separate manual on how to use the pedal. The best reference is either this wiki page, or the instruction manual (linked above in General Information) at Buildyourownclone.com which describes the architecture of, and how to build the pedal.
Schematic
- Additional Sources
