Difference between revisions of "Amp Selector FX Router"
From Thermionic Studios
m (→Phase Inversion) |
m |
||
| Line 12: | Line 12: | ||
==General Information== | ==General Information== | ||
http://byocelectronics.com/ampselectorinstructions.pdf | http://byocelectronics.com/ampselectorinstructions.pdf | ||
| + | |||
| + | There was also a thread or two on the byoc discussion boards about enabling a phase inversion switch on Output B: | ||
| + | http://www.byocelectronics.com/board/viewtopic.php?f=52&t=44330 | ||
==Phase Inversion== | ==Phase Inversion== | ||
Revision as of 08:04, 13 February 2018
BYOC Amp Selector FX Router
Controls
- Switch 1 - "Transformer 1 Isolation Switch":
- Switch 2 - "Transformer 2 Isolation Switch":
- Footswitch 1 - "Both/One":
- Footswitch 2 - "A/B":
General Information
http://byocelectronics.com/ampselectorinstructions.pdf
There was also a thread or two on the byoc discussion boards about enabling a phase inversion switch on Output B: http://www.byocelectronics.com/board/viewtopic.php?f=52&t=44330
Phase Inversion
| Electronic Part | Action | Phase State |
|---|---|---|
| IC1a | Inverts | Inverted |
| IC1b | Inverts | Reverted |
| IC2a | Inverts | Reverted |
| IC3a | Inverts | Inverted |
| IC1b | Inverts | Reverted |
Pedal Manual
As of this time, BYOC has not issued a separate manual on how to use the pedal. The best reference is either this wiki page, or the instruction manual (linked above in General Information) at Buildyourownclone.com which describes the architecture of, and how to build the pedal.
Schematic
© Copyright 2011, BYOC LLC.
- Additional Sources
